Hi there I am new to the Ram world. but here is the problem. I have had codes for 3 and 6 misfires. I have replaced the plugs, wires, coil, cap and rotor. I will clear the code but can still feel it in my pedal. then about a tank of gas later then it will pop those codes again. any ideas? thank you for your time.

 

Check routing of plug wires. There is a TSB in the FAQ/DIY section.

 

Thank you I'll have to check that out....if that doesn't work should I look at getting a new reluctor?

 

Compression or leak-down test the motor. Also read the plenum sticky thread.