2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

98 Ram Fuel Pump

Thread Tools
 
Search this Thread
 
  #1  
Old 04-03-2013 | 04:05 PM
kc58ab's Avatar
kc58ab
Thread Starter
|
Registered User
Joined: Aug 2012
Posts: 11
Likes: 0
Default 98 Ram Fuel Pump

I'm fairly certain the fuel pump has gone out on the 98 Ram....question is how much would you expect it would cost to repair with a mechanic?
 
  #2  
Old 04-03-2013 | 04:12 PM
Matt Nickerson's Avatar
Matt Nickerson
Record Breaker
Joined: Aug 2011
Posts: 1,095
Likes: 0
From: Southern Massachusetts
Default

Why do you suspect the fuel pump is going out? If you can get your hands on a fuel psi tester (auto parts stores should loan them out) then you should test it the pressure at the rail. Should be ~49psi. If the pump is bad, replace it with a Denso or Delphi brand only... Or you will find yourself having to replace it again. The pump assembly costs $145 on RockAuto then factor in about $80 an hour for a shop to put it in. I would assume it takes 2-3hrs?
 
  #3  
Old 04-03-2013 | 04:19 PM
gertie240's Avatar
gertie240
Captain
Joined: Jun 2010
Posts: 556
Likes: 2
From: San Antonio,Texas
Default

around 2 hrs.
 
  #4  
Old 04-03-2013 | 04:22 PM
kc58ab's Avatar
kc58ab
Thread Starter
|
Registered User
Joined: Aug 2012
Posts: 11
Likes: 0
Default

I'm fairly mechanically ignorant but it was making this loud annoying noise last week, then last night it just sputtered and died like whenyou run out of gas. I had gas in it. When you try to start it will run for a few seconds then sputter and die. From what I can find online searching it sounds like the fuel pump. Thanks for the info!!!
 

Last edited by kc58ab; 04-03-2013 at 04:24 PM.
  #5  
Old 04-03-2013 | 04:34 PM
MedicNathan's Avatar
MedicNathan
Veteran
Joined: Mar 2010
Posts: 262
Likes: 0
From: Sioux Falls, SD
Default

Its actually a fairly easy fix to do at home. Just drop the tank and swap the parts really. Took me about 3 hours, but better than paying a shop $150
 
  #6  
Old 04-04-2013 | 11:26 AM
Blackbox19's Avatar
Blackbox19
Amateur
Joined: Feb 2013
Posts: 48
Likes: 0
Default

Swapping out pumps takes just a few minutes. tank drops down and you disconnect everything. I used a piece of wood and hammer to tap the ring off that holds the pump in and installed another.. If you got U pull it yard, you can get lucky as most pull the tanks to drain and set the pump up in back,. I took a 12 or 24 volt battery from my drill out to the yard and hooked to the pump to make sure it worked... Found a brand new one, watch also the new pump comes with a adapter pig tail for the electrical connection. thats how I knew the pump was new, I could see the pig tail connector.

These pumps are $$$$$$$$ thats why I went to junk yard,
 
  #7  
Old 04-04-2013 | 11:28 AM
Gary-L's Avatar
Gary-L
Legend
Joined: May 2005
Posts: 8,648
Likes: 6
Default

Originally Posted by Blackbox19
Swapping out pumps takes just a few minutes. tank drops down and you disconnect everything. I used a piece of wood and hammer to tap the ring off that holds the pump in and installed another.. If you got U pull it yard, you can get lucky as most pull the tanks to drain and set the pump up in back,. I took a 12 or 24 volt battery from my drill out to the yard and hooked to the pump to make sure it worked... Found a brand new one, watch also the new pump comes with a adapter pig tail for the electrical connection. thats how I knew the pump was new, I could see the pig tail connector.

These pumps are $$$$$$$$ thats why I went to junk yard,
Running a fuel pump from a junkyard vehicle is akin to buying used underwear, especially if the pressure regulator isn't replaced.
 
  #8  
Old 04-04-2013 | 02:23 PM
Blackbox19's Avatar
Blackbox19
Amateur
Joined: Feb 2013
Posts: 48
Likes: 0
Default

Money does not grow on trees around me, so I do what I can. And a new pump can go out just as fast as a old one. So do what you want. I prefer to save some money. And waiting 5 days for rock auto to send one or a day for the local parts place to get one in.
But a electrical pump that is clean and not broke, works just as good as a new one. If the sock is good that tells you the pump is more than likely not got any trash in it.
 
  #9  
Old 04-05-2013 | 06:27 PM
ledman's Avatar
ledman
Rookie
Joined: Feb 2013
Posts: 92
Likes: 0
From: Orange County, California
Default

Is there a DIY thread around here on the process to change out the fuel pump on a 2nd Gen ram? Thanks
 
  #10  
Old 04-05-2013 | 06:44 PM
zman17's Avatar
zman17
Retired Moderator - RIP
Joined: May 2008
Posts: 18,729
Likes: 17
From: NH
Default

Originally Posted by ledman
Is there a DIY thread around here on the process to change out the fuel pump on a 2nd Gen ram? Thanks
No, but all the info can be found in a Haynes manual and by downloading the correct free service manual from the FAQ/DIY section.
 



All times are GMT -4. The time now is 04:39 PM.