Hi, am gearing up to replace the clutch in my '99 V6 Ram. I did a search but didn't find a similar thread, so was hoping to see if anyone had any suggestions or tips and tricks. I have changed a number of clutches but mostly on older GM muscle cars so I have the basics down; was just looking for anything special to look out for on this truck.

I have a new disc, pressure plate, throw out bearing, and u-joints. Anything else I should replace while I am in there?

Thanks in advance!

 

I think doing the slave cylinder is probably not a bad idea.

 

Slave is external and the wholes system is meant to be replaced as a sealed unit. No reason to do it with a clutch job since the trans doesn't have to be dropped to do it.

Remove the crank sensor before bulling the trans, otherwise you risk damaging it.

 

Thanks for the advice, it is appreciated!