Ok so I just finished my manual 5 speed swap in my 99 ram actually it's been like a week I screwed the air lines that run from the t case to the actuator on the front axles cause they were cold and fragile !

My question is can I just run small rubber line rather then those stupid plastic lines that snap and leak?

Thanks guys

 

Yes. I think that's actually considered an upgrade.

Or if you're feeling ambitious, and you have the money. You could look into a manual hub conversion which would eliminate the CAD vacuum system

 

I was actually looking into that system where it deletes all the air lines and has a cable cad that runs into the can for 150$

 

The posilok? There's a couple people around here that run it. They all seem to enjoy it

 

Mr Ham Bone was reffering to something like this...

http://www.emsoffroad.com/store/inde...roducts_id=263

 

I was just talkin bout running my own air lines or ya..

That posi lock that uses a cable, it's only 160$ or so