thanks for all the info I ended up getting a 2.5 in lift spacer for the front and a 5.5 in block for the rear so I can replace the 3 in factory block instead of using two blocks and I also got 1/2 in spacers for the wheels probably wont be enough to gain full clearance but should help more than not ill upload some pics when I finish the install and mine has just over 209k and still stong enough to pull 3-4 ton of dirt at a time

 

after I do the lift in the rear the bump stop contact plate will be gone as I am replacing the factory block is there anything that can be done to replace that without fabricating something

 

Wonder if L/D 2500 blocks from a 94-96 would work? They are 5 inch, and have the bump stop, and also are the correct width for your springs.