When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
I'm considering picking up a set of Edelbrock 61779 heads for use on a 408 motor I'm planning to build for my truck. Please share any experiences you have encountered when using these heads on a Dodge magnum short block.
What about a pair of these: http://www.ebay.com/itm/NEW-EQ-IRON-RAM-DODGE-318-360-MAGNUM-OHV-CYLINDER-HEAD-/171187672867?pt=Motors_Car_Truck_Parts_Accessories&hash=item27db949723&vxp=mtr. Quite a bit cheaper.
I'm aware of them, however, I have a line on a pair of Edelbrocks, hence the question. Besides, I like the aspect of well made aluminum alloy heads and a cast iron bottom end if I can acquire the parts reasonably.
Anyone using Edelbrock 61779 heads?
