When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Non Adjustable H&S 1:1.7rr's with resurfaced heads?
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Probably. Lifters will compensate for the most part. Still and all, wouldn't hurt to put it all together, and roll the engine over by hand a couple times, to verify you don't run into any problems.
I'm letting the kid do the work. He's pulling the valve covers now. He's never done much work before so it's going slowly and there is a little whimpering. Too bad he isn't old enough to have any of the beer....
Old enough to pull an engine he's old enough for dad to cough up a beer.
C'mon dad. Lol
Yup, I was pulling down motorbike engines and drinking beer (a controlled amount) at 6yrs... didn't hurt, and took all the mystery out of drinking, so I was the sensible one when everyone else was on a bender (not knowing their limits).
However, in this day and age, I wouldn't let anyone see you feeding a minor a beverage.