When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Late reply but... Haha, 30,000... and up. Sounds about rite. And so far the drb runs around 3 gs. At least what I've found. The only ones I've found that where cheap Chinese where this foxwell nt 510 ($150) a vident ilink 400 ($160) and a icarsoft bc2 for ($150) as well. On eBay.
They all say there the most advanced obd2 readers... blah bla blah bla blalalalalalah. BS.
I can't remember all the names but just type "Snap on scanner vs" into YouTube and you'll see all videos comparing them. DRB I found a few for 900 and below when I looked a few weeks ago. I know Harbor Freight has one that claims it will ldo anything for $189? But I'm not sure if it actually does.
I can't remember all the names but just type "Snap on scanner vs" into YouTube and you'll see all videos comparing them. DRB I found a few for 900 and below when I looked a few weeks ago. I know Harbor Freight has one that claims it will ldo anything for $189? But I'm not sure if it actually does.
Ill take a gander.. I think I looked in to the harbour freight one but I don't think it even did tranny codes, I know it did air bag and abs. I might try one of these 3, and see how it goes. I'll let you know how it goes when I get a chance to get my hands on one.
Ill take a gander.. I think I looked in to the harbour freight one but I don't think it even did tranny codes, I know it did air bag and abs. I might try one of these 3, and see how it goes. I'll let you know how it goes when I get a chance to get my hands on one.
They're usually covered by the PCM anyway. I mean TCM -> PCM -> Scanner. So when people scan for codes they end up pulling engine and transmission codes at the same time.
They're usually covered by the PCM anyway. I mean TCM -> PCM -> Scanner. So when people scan for codes they end up pulling engine and transmission codes at the same time.
05-03-2018, 02:18 AM
