When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Replaced tps and checked all wire voltage and ground still gettting code 24 and truck stalling when letting off gas going slow. Plus sporadic trans shift. Only other code is o2 sensor. Ideas? 1995 5.9
Did you test the TPS as described in the service manual, back probing the sensor output ? More than 200 mV at idle and less than 4.8V at WOT ? Might want to jiggle the throttle blades a bit at off throttle.
Did you clear the code after you replaced it? If not clear it and test the return voltage the pcm is getting. Code is for an over voltage going back to the pcm.