01 Dana 60 axle seals
#41
Hey guys so got a slight problem. So I got the new bushing in and everything back together parts took forever was driving me nuts. As I was getting the bushing to seat some of the lip broke off of the bushing on the side closest to the rear of the axle tube. I'd say about half an inch of the lip going around broke off. The part that the splines go through is all good though should I worry? I tried finding a bearing, but being an 01.5 it has larger diameter axle tubes than the Dana 60 from 94-99 which they had a bearing. They'd be to small though about half an inch to small in diameter.
Last edited by BM9NBA2; 10-13-2021 at 10:19 PM.
#42
I'll post a picture of the bushing tommorow and how much of the lip broke off. I mean the lip shouldn't matter to much anyways right? If you think about it the bearing doesn't have a lip at all the entire bearing just sits inside the axle tube on the 94-99 Dana 60s
Last edited by BM9NBA2; 10-13-2021 at 10:38 PM.