2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Intake plenum gasket

Thread Tools
 
Search this Thread
 
  #21  
Old 06-13-2007 | 10:12 PM
dhvaughan's Avatar
dhvaughan
Hall Of Fame
Joined: Jul 2006
Posts: 12,204
Likes: 8
From: Gainesville, Ga.
Default RE: Intake plenum gasket

the hughes bolt/gasket kit comes with good rubber gaskets as well.
 
  #22  
Old 06-13-2007 | 11:15 PM
mcss8541's Avatar
mcss8541
All Star
Joined: Feb 2007
Posts: 946
Likes: 1
From: EL CAMPO, TX
Default RE: Intake plenum gasket

Where do I get this Hughes kit. I followed the advice of one of the members when my engine started to idle a little rough during warm up and I heard the knocking during hard acceleration. I was told to get a flas light and open my throttle body plates and look inside the plenum for any signs of oil. I did that and sure enough there was some on the passenger side only about an inch wide. It wasn't runny but dried on. This post is a big help but I need to get this kit(s) that everyone is talking about. Thanks!
 
  #23  
Old 06-13-2007 | 11:20 PM
dnfd737's Avatar
dnfd737
Veteran
Joined: Mar 2007
Posts: 281
Likes: 0
Default RE: Intake plenum gasket

do an internet search. its easy to find.
 
  #24  
Old 06-13-2007 | 11:22 PM
gottarottie's Avatar
gottarottie
Registered User
Joined: Jan 2007
Posts: 42
Likes: 0
Default RE: Intake plenum gasket

Go to http://www.hughesengines.com/, the kit is great! I just put mine in last weekend, i can't see how people take a few days for this change, If your limber enough don't bother taking the fan shroud out, you can damn near climb into that engine bay. Took me 6 hours straight, that is including putting on my new cold air intake. The longest part was scraping the old gasket material off. But yeah hughes is the best, they have some staright up stuff there.
 
  #25  
Old 06-13-2007 | 11:26 PM
mcss8541's Avatar
mcss8541
All Star
Joined: Feb 2007
Posts: 946
Likes: 1
From: EL CAMPO, TX
Default RE: Intake plenum gasket

Thanks the website was informative. I no longer have a fan shroud or fan blade, I replaced it with a Flex-A-Lite prt # 294 dual electric fanwith thermostat control. So now whenever I work on my engine I stand infront inside the engine bay on the bar that runs across to each wheel at the bottom.
 



Quick Reply: Intake plenum gasket



All times are GMT -4. The time now is 11:50 AM.