Wear it proud mutha...
Wear it proud *****...
I am a little late in the game...but i finally got my DF bling...
should have put this in the genral discussion section, my apologies.
should have put this in the genral discussion section, my apologies.
Last edited by jkeaton; Aug 12, 2010 at 05:40 PM.
went with silver, it will go well with the bed stripe if i ever get it put on! called three places that do wraps today to see how much it will cost to have them put on, the cheapest was $60! (minimum 1 hour labor charge). Had no idea it would be so expensive!
Veteran
Joined: May 2010
Posts: 481
Likes: 0
From: Wesley Chapel, FL
I had some people quote me $70-$100 i was like the damn things didnt even cost that much and you want that much to put them on lol... I found a guy local that did them out of his house and I think he charged me $50 which after watching him put them on it was worth the money and I am glad I did not attempt to do them myself. Those silver Dodgeforum things will go good with the silver bed stripe though 
Veteran
Joined: May 2010
Posts: 279
Likes: 0
From: Louisiana
Mine was a freebee but i think he told me it would be $60 if somebody wanted one installed $50 if you do it your self. After watching him do it i would pay the $10 to have it installed.
Trending Topics
Veteran
Joined: May 2010
Posts: 481
Likes: 0
From: Wesley Chapel, FL
Jerry the guy wants Keaton to pay $60 just to install the stripes that Keaton already owns. I paid $50 to have the stripe I had already paid $70 to have made. Sounds like your guy is priced a lot better. I didnt mind paying to have mine installed because I know if I had tried it then my stripe would of been in a crumpled up ball in my drive way instead of on my truck lol.
Veteran
Joined: May 2010
Posts: 279
Likes: 0
From: Louisiana
Jerry the guy wants Keaton to pay $60 just to install the stripes that Keaton already owns. I paid $50 to have the stripe I had already paid $70 to have made. Sounds like your guy is priced a lot better. I didnt mind paying to have mine installed because I know if I had tried it then my stripe would of been in a crumpled up ball in my drive way instead of on my truck lol.
Guest
Posts: n/a
I put mine on. Just measure and put masking tape at the top and bottom to make sure your lined up. Then a heat gun if you have a hard time laying down around the curves. Mine took maybe an hour to do both sides. Just take your time and measure twice.
My tape indicated 3 things. The top of the bed where I wanted the tailgate side to end. The bottom of the bed side where I wanted the tailgate side to end. (Just like the top piece). And the last piece marked where the design was. This helped align the opposite side, since I could measure from the to to the design to make sure they were the same.
My tape indicated 3 things. The top of the bed where I wanted the tailgate side to end. The bottom of the bed side where I wanted the tailgate side to end. (Just like the top piece). And the last piece marked where the design was. This helped align the opposite side, since I could measure from the to to the design to make sure they were the same.