i was installing remote start , hooking up park lights, think may have shorted something...now have high beam ind, abs ind, slippery road ind all on and no gauges working...could somebody tell me what i may have damaged? thanks bikergn52

what did you wire the remote start to

directions said to use pink/red wire at light switch...at end of column it says resistor...does that nean i should add a resistor ?

umm when you wired them into the lights you kept in tact right like you did a 3 way splice?

oh wait never mind.. and the directions said resister?

yes...i heard small pop...now no gauges and indicators on...even without key on

sounds like it shorted out check fuses and you made sure no nmetal could contact the wires were you spliced it right.

hook everything back normally and check your fuses.

thats not good...