When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
It's been a while since I have done much with the truck but I did put in a new radio and some led's. I'll get some night shots later so you can see how they look.
Nice install on the radio. How did you wire the LED's on the mud flaps, oh and nice to see you still have the "nice" NY plate not the ugly yellow and blue one
Thanks. As of right now I had installed a T-Connector so I could have a 4 pin harness for a smaller trailer if need be when I move again. It comes with a 4 pin attached. Once I get the wires cleaned up I will get a picture of how they are wired. They make this as a kit with them pre installed on mud flaps but I didn't like the ones they came on so I got a set from NAPA where I work.
On a side note I got my pinstripping on and good to go today so i'm excited. Going to get some pictures now of it and my head light covers.
Do you guys have any problems with your windows closing with the in channel visors? My rear windows are pretty slow the way it is .... idk if they have enough power to actually close with any added resistance. Lol
Do you guys have any problems with your windows closing with the in channel visors? My rear windows are pretty slow the way it is .... idk if they have enough power to actually close with any added resistance. Lol
My in-channels (EGR) do not affect the windows at all. I removed the Mopar stick on ones and couldn't be happier.
That tape was a bitch to remove though!
Hey BackWoods if your interested I would be willing to part with most of my roll if you wanted to do it. The only way I could get it from work last year was like 100 ft roll or something and have like 3/4 of it left if not more.