Hi All,

I've read (and reread) the manual but I'm still unclear on how to program my 2 factory fobs for Memory Presets 1 & 2? Seats, mirrors, Radio etc... are programmed without issue. I can't get the fobs recognized for preset 1 and 2.

Can anyone provide a SIMPLE step by step for doing this?

I have a 2013 Durango Citadel w/Hemi and all options.

I've done this with at least 2 other Chrysler cars without any problems.

Thanks,

 

From what I remember, while the truck is in run, press the s then the number memory button then within 6 seconds press the lock button on the keyfob. I think in the vehicle settings menu there is an option to turn on and off the option to link them if I am not mistaken.

 

Are you saying the seats will move automatically when you unlock with a certain remote? I've been trying to get that to happen for a while and just gave up. I miss that in my old saab.

 

They can but I just tried it again and couldn't get it to work. I think you need to use the key instead of the push button and I don't know how to pop off the button lol

 

It pops off super easy. At 6 o'clock on the push button it is cut out to slide a key under and pop it off.

 

I didn't even know you can do this with the key fob. If someone figures it out please post it up.

 

Thank you sir. Even though I bought my D with 16k on it, I still treat it like new and was nervous about prying it but it was easy. But I've got no issues installing a CAI and tuner. Lol

 

I set mine without popping the button out. My seat goes automatic back for easy exit and upon start goes to the preset seat position for position one/ key fob.

 

same with mine!

 

But how do you program the keyfob to the memory? Like if my wife has her keyfob and unlocks the doors it, it should go to memory two.