does any one know where the tail light flasher is located on durango wanted to install led brake light bulbs and wanted to fix the hyper flash with the led flasher

 

You will probably have to put load resisters in as well. I have LED's in my outer tail lights, and I have the lamp out message for each side, and the hyper flash as well. I am putting them back to regular bulbs and leaving the LED's in the tailgate. Unless someone knows of a replacement LED for the outer tails with no issues.

 

There are no flashers any more; everything is controlled and monitored by the computers.

It is possible to have LEDs without Hyperflash, but you must place a resistor across the brake/turn wire; the computer monitors the return voltage and if too many volts return (or none) the computer 'thinks' a bulb is out and gives you the warning and hyperflash.

Keep in mind that this A: requires tapping into your brake light wiring (so if you're not comfortable you may want to skip this one) B: you will not be notified if one of your LEDs fails, the computer will always think it's working and C: careful where you mount a load resistor as by their very nature they heat up.

 

Thanks for all the info ,wanted to see how the 2014 durango tail lights will work they have led turn and brake light. When they are available

 

Which ones did use/where did you get them? I'm planning on switching mine over before I tint my tails. I've got no problem installing resistors to stop hyperflash.

 

Got my bulbs and resistors from v-leds.com