Fender Stripes installed
Thread Starter
|
Amateur
Joined: Dec 2013
Posts: 32
Likes: 0
Stripes
Wow! I think I may be doing that one. How did you choose the color of the stripes? Did they just have material on hand that you choose from?
Your color looks closer to mine (mineral Grey metallic) than the maximum steel though. Mayby it is the light.
I would love to see more pics.
Also, what kind of shop did you go to? Not sure where I would get that done local...
Your color looks closer to mine (mineral Grey metallic) than the maximum steel though. Mayby it is the light.
I would love to see more pics.
Also, what kind of shop did you go to? Not sure where I would get that done local...
The shop I used was Rigo's Graphics in El Paso 915-591-8676
Thread Starter
|
Amateur
Joined: Dec 2013
Posts: 32
Likes: 0
Yes a bit darker for contrast, just a Flat Black....they do look different when the sun hits them....
Last edited by JBuda; Dec 24, 2013 at 10:58 AM.
Thread Starter
|
Amateur
Joined: Dec 2013
Posts: 32
Likes: 0
Size
Stripes are about 5-1/8" wide with 1/4" space in between. They just lined them up with my top hood line, ran them down and trimmed and tucked the bottom, they were initially pretty long until cut to fit at the bottom.
Veteran
Joined: Sep 2013
Posts: 285
Likes: 0
From: Illinois
I bought a sheet of flat black vinyl. Then I cut them to 3" wide. I didn't want them as wide as the factory ones. I just wanted to break the truck up some since it's so long. I wouldn't change the way they turned out. Plus I did not run mine up in the hood at all.
Last edited by Gqjeff; Dec 24, 2013 at 11:20 AM.
Captain
Joined: Apr 2013
Posts: 602
Likes: 1
From: Arnold, Maryland
And then there is always Plasti-Dip, make as many errors as you want with no consequences, except a thinner wallet.
