anybody runnig these headers i found them on e-bay cheapest ones i found so far just want to know with there worth a ****

 

I almost got those last week, they look decent to me. Thick plate for manifold & flange, numbered even, pretty fancy.

If you do get them, let me know about fitment. Are you replacing the factory pipe to the cat? I was considering these headers and direct replacement cat from Magnaflow.

 

I don't know anybody with them on a Ram, but I do know they have a strong following with the 4 cylinder ricer crowd...

 

Dang!,Thoose do look like a pretty good deal.That may be my next mod.

 

I personally don't have them BUT on other forumz the people that do have them have had only good things to say about them, especially for the price. I also havent read anything about fitment issues... But like I said I do not have them or seen them in person.

 

have a set on my 04 qc hemi 4x4.hemi. they did bolt up to the existing exhaust factory Y pipe). i had to remove the started to get to the drivers side flange bolts. other than that, not a bad install. had to retorque once after about 100 miles. all good since then!

 

Does putting headers on require welding or is it all bolt on?

 

Should be all bolt on, flanges are thick too.

 

i got a set for my 4.7l. i ran them open for a while till i could get to the exhaust shop so i could get the connected to the rest of the exhaust. so far i like them no problems

 

Only Quastion I have is do they work on a 4wd cause it says 2wd only?