Well thank you and happy 4th.


And 1k for lining all that?!?! My buddy rhino lined his whole entire 2500 for only $700. I don't understand how he could do that and you only wanting to rhino line a few things and yet cost more. That is absurd.

 

Well it was close enough to call it 1K, i was looking at doing the bed over the rails which is like $500 plus, and then the grill, front and rear bumpers and rockers along with the flares....

 

Oh got ya. That is crazy. Idk maybe he didn't get the actual rhino lingings. Might of got one of those knock offs.

And as for the lights, I hope I don't get told it's too dark. That would be no bueno. Did you paint them or buy them black? I ordered all of them in the RECON smoked.

 

you will be fine with the Recon's, i sprayed mine with VHT....lol

 

Haha with VHT? yeah I'd imagine they'd say it was to dark lol

 

My truck already has a rhino liner, and just to have them spray it on my rails will cost $150. I am thinking about just taping it off and doing them myself.

 

Is there a preferred way to prep the fenders before installing these flares? I know it's simple but just wondering bc sometimes shoddy prep equals bad results.

 

i just cleaned mine with a little dawn and warm water to get off any wax where the tape would be sticking....other than that man, you drill 4 1/8' holes in each fender then remove the factory screws that hold the liners in and simply put them on....i did the screw first and then peeled the tape off....

Also the rear ones might be a tad different for you, i have the factory wheel well liners...and so i had the two screws for the front half of those....if you dont have the wheel well liners then i suggest picking up some of those screw or getting the liners.

 

prep to paint or what?