Thanks for the compliments guys!

 

http://www.homedepot.com/Electrical-...&storeId=10051

 

Is that what you used ewing? The picture on the website looks different from what you have unless its just the angle you took the pics at

 

yeah the picture on the hd website looks a little funny, but I think that's it. That makes it look long and skinny, but the pictures from my truck are more true to life I think. But that should be the part. It's basically like the only thing close to that in the electrical section, hard to miss i think.

 

How did you attach the air temp sensor?

 

wow! I have seen A LOT of home made CAI (even made a few myself) and THAT looks spectacular! if you slapped a K&N sticker on there I'd swear that was an aftermarket part. Any plans on making a heat shield around the filter?

 

I just drilled a hole and put some silicon around it. It seems to be working well. I also cleaned it up before I re installed it.

 

You mean something like this?





Haha... I found that sticker in the bottom of the filter box when i was going to recycle it. Thanks for the compliments though, nice that other people like the look. Maybe it will start a trend on this forum... haha.

 

You for sure started a trend

 

I agree. I just need to figure out how to keep it from flopping around.