DodgeForum.com

3rd Gen Ram Tech 2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Pyrometer Install

Thread Tools
 
Search this Thread
 
  #1  
Old 02-25-2008, 12:55 AM
R8DRROB's Avatar
R8DRROB
R8DRROB is offline
Thread Starter
Join Date: Feb 2008
Location:
Posts: 10
Likes: 0
Received 0 Likes on 0 Posts
Default Pyrometer Install
I had a question for some of you CTD guru's. I followed some instructions that I found in the Cummings Forum on how to install an EGT Gauge. It told me to use a 7/16" bit and a 1/4"NPT tap. Well come to find out the fitting that came with my Auto Meter EGT gauge is 1/8".So my question is thiswhere canI get an 1/8" x 1/4"fitting.Im not sure if brass would hold up under those type of temps. Any help here would be appreciated. Thanks
 
Reply Like
  #2  
Old 02-25-2008, 01:07 AM
motorider228's Avatar
motorider228
motorider228 is offline
Champion
Join Date: May 2006
Location: GFY
Posts: 2,515
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Pyrometer Install
Why don't you try out the cummins section, you will have better luck there getting the answer you need.
 
Reply Like
  #3  
Old 02-25-2008, 01:30 AM
R8DRROB's Avatar
R8DRROB
R8DRROB is offline
Thread Starter
Join Date: Feb 2008
Location:
Posts: 10
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Pyrometer Install
I didn't relize there was a CTD section.
 
Reply Like
Back to Subforum
3rd Gen Ram Tech
View Next Unread
paint job




Advanced Search
Quick Reply: Pyrometer Install


Reply Closed Thread Share
Forum Jump

All times are GMT -4. The time now is 04:08 PM.