I searched for this topic and found a few replies to this, but was wondering the most effective way to take care of the leak that I get on my driver's side opening. Replaced the seals dues to the ripping and tearing from the old designs last fall, but didn't notice the leak until about a month ago. And why only the driver's side? I replaced both sides, logic would tell you that both sides should leak, right?

And just to narrow it down, I believe the leak to comes in at the top half of the door, rolls down to the underside of the door trim panel (where it's rusting the lower front screw) and than drips onto the carpet.

tia for any advice and input! [sm=confused06.gif]

 

ttt