I have a '08 Ram qc big horn, how much can I lower this without rubbing? I'm guessing with the 32.7in tires, maybe 2/4. If I wanted to jump up the get in I would have bought a 4x4, and lifted it...lol. I have family that has a hard time getting in, I just want to level it, but then again if I lower the back, I'd rather lower both. How low has anyone taken there gen3, being that most still have warrenty, but lowering won't void my lifetime powertrain warrenty anyways.

 

It will change the pinion angle and they could argue that point if the rearend fails.

Just food for thought.

 

well i have a 2/4 drop on mine....runnin a 305/45/22 tire on it and no problems with rubbing.......you can install shims in the rear to get the pinion angle back to within spec

 

Did you put a flip kit? Some say you get 4in, some 6in with a flip kit, so I'm lost...lol. Your truck sets good, thats what I'm, wanting, low, but not to where you drag on everything, I still pull my trailer, and '01 Dakota. As for the dealership, pinion angle won't tear a tranny, of blow, and engine, and the rearend should be fine.

Where's a good place to get a 2/4 kit, and what am I looking at?