When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
3rd Gen Ram Tech2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Hey check it out finally got the look i wanted, it took about 4 hours of cussin and throwin tools and four trips to advanced. I got it done, put in a truxx 3-4 inch leveling kit with the shock relocation brackets. I tell you what though i used the ball joint remover tool on the drivers side torsion bar, and was gettin so pissed cause there was no room to get it situated to where it would clamp down on the right part. Went back to the store got the biggest c clamp they had and used it on the passenger side and snapped that damn thing right off in about 5 mins lol! After calming down, i found it way easier to finish lol. well tell me what yall think...... yes i know tires are going soon....
you know i washed all the mud off last week, stupid gps keeps taking me to all these mud holes! but hey if i didnt want to get muddy i would have bought a 2wd
thats nice man need to get some bigger tires though makes it look small but i cant wait to level it with a tlift and then a 3" body lift and it will look like i want it
you know i washed all the mud off last week, stupid gps keeps taking me to all these mud holes! but hey if i didnt want to get muddy i would have bought a 2wd