Okay, I decided to try and remove my cowl today to clean, etc. I got the passenger side off but cannot get the driver side off (its two pieces).

Two torx screws, six push clips, four big push clips for insulation, remove strip seal, wire tab on passenger side, and then wiper fluid tubes. What am I doing wrong???

 

No1 has any imput?

 

Dude my wiper cowl is only held down by the hood and some 3m tape....Idk where you got all the other stuff?!?

 

he means the actually wiper cowl on the truck not the aftermarket piece

 

I have never removed mine so I can't really say but i think 04 did his not too long ago so maybe he will chime in.

 

Smart Whiteliquid...yea Im trying to take the actual cowl off. Wanting to paint it. I heard it is a biatch to remove the wiper heads and get them back on strait, but I don't see how you can take the driver side cowl off without removing them.

 

no you have to remove the blades im pretty sure. are u doing that painted wiper cowl gb on dt?

 

I was but I got a speeding ticket and it really offset my mod fund and i thought I was going to get back to where i could and bam! guess what? whoever keyed my truck yesterday probably will be happy to hear that its going to cost over $500 to fix

 

ouch man that sucks. are u gonna claim it on insurance? same thing happened to me but it was a hit and run instead of a key that was 2k...

 

ohh ive already been rear ended twice, this is my #2 bumper (thanks to a buddy that bought a roll pan) but the hitch really helps that

Umm I MIGHT be able to claim it without hurting me. MIGHT they said, and my deductible is only $50. But if it is going to go against me I will have to pay out of pocket. And I am not out of school yet so I am working off of savings