I had been running a Moroso spiral flow dumped under the bed. It's a single in/out, so a Y was put after the muffler into two 2.5" stainless pipes into 3.5" stainless tips.

The real kicker? Only $220 and only took an hour to do. The spare wasn't moved, and not a single bit of exhaust pipe is hanging down. It is by far the nicest exhaust job I've seen in a long time. Everything is tucked real high and tight. I had to do something different other than the hillbilly straights out the back.

I'll take more pics tomorrow to show how it was routed.

 

I don't think I've seen exits like that before.. Behind the tires like mine, but then they kind of angle down. Kinda cool looking.

 

mine exit behind rear tire but are tucked up high against the rear fender at low angle with slash cut tips. i hat eteh straight out teh back look but to each his own. how does it sound?

 

You should post a sound clip too.....and where are those other pics??? Let's get a move on here!

 

Sound Clip! Let's hear that bad boy!

 

Where are the sound clips? Any good exhaust thread needs to have a sound clip for us!

 

most definately cool lookin.. where r u in pa.. and third off... SOUND CLIP! =)

 

Yeah, where are you in PA? Didn't even notice that PA plate on there until 96 pointed it out.

 

What are you calling me a hillbilly cause i got straits?? jk I think i am just a little

 

What are you calling me a hillbilly cause i got straits?? jk I think i am just a little myself