Quad Bi-Xenon projector retrofit setup
#42
Yeah, I was kinda torn between 2.5" and 3", but with seeing the 3 next to the 2.5". There's no way a single bi-xenon 2.5" projector would look normal sized in my 08 housing...lol The only issue with bigger projectors is the light pattern isn't as wide due to the convex of the glass isn't as much as the 2.5". The more bend to the glass, the further out the the side the light will travel.
As far as the commment about 06+ headlight being bigger. They are just taller. They aren't wider or any deeper than the earlier headlights. they have a similar shape and size besides height. That's all. The install wouldn't be any easier. That big plastic piece in the front still tapers down to a small backside just like weed has. maybe the 06+ is a teeny bit taller, but I doubt it. the front plastic just makes the light look much bigger.
As far as the commment about 06+ headlight being bigger. They are just taller. They aren't wider or any deeper than the earlier headlights. they have a similar shape and size besides height. That's all. The install wouldn't be any easier. That big plastic piece in the front still tapers down to a small backside just like weed has. maybe the 06+ is a teeny bit taller, but I doubt it. the front plastic just makes the light look much bigger.
#43
#44
THX guys, and yeah there is plenty of room for 3" projectors with a shroud that has the base size of 5" +/-. The only reason I did 2.5 in the turn signal size is because I knew I had less room to work with.
Im doing my CST 3" lift springs tomorrow morn but will get back to this after that.
Im doing my CST 3" lift springs tomorrow morn but will get back to this after that.
#47
#49