When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
3rd Gen Ram Tech2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
If I had this done by a shop, because I am limited with cuttin tools, they won't have to wire anything up will they?
All you need is a hack saw to cut. You don't need to weld it up, you could always clamp it. Then you wouldn't need a shop to do it for you. I am wishing that I didn't weld mine now that I am pulling out all the piping when I put my headers on.
Just not sure how I'll get the wiring into the cab to place the controle module somewhere (most likely in the center console since there is a power supply in there).
Just not sure how I'll get the wiring into the cab to place the controle module somewhere (most likely in the center console since there is a power supply in there).
There are plastic plugs in the fire wall that you can drill through and feed wiring through.
I don't have any on hand but I could try to get one for you. Since it is under the dash it might not turn out, but I can try...........after it stops snowing here