View Poll Results: How would you like the mount better?
Back the way it was (black powdercoat)
3
6.52%
This way (polished aluminum cover)
11
23.91%
Diamond Plate cover (to match my toolbox & bed rails)
32
69.57%
Voters: 46. You may not vote on this poll
Newest little mod and need an opinion...
Thread Starter
|
Administrator
Joined: Jul 2007
Posts: 24,686
Likes: 21
From: South Georgia/East Florida
But if I'm gonna spend almost $80 on a sheet of diamondplate, then I'm gonna figure out other mods to make with the 2/3 of the sheet I don't use for this piece...
Record Breaker
Joined: Oct 2008
Posts: 1,158
Likes: 0
From: Edmonton Ab Canada
Well I'm gonna polish the sh*t out of them tomorrow and see how well they match the stainless grill guard. I'm going up there to make the grill and a piece for the hood scoop. I may buy a sheet of diamondplate and make another anyway, since this one is saved in the machine.
But if I'm gonna spend almost $80 on a sheet of diamondplate, then I'm gonna figure out other mods to make with the 2/3 of the sheet I don't use for this piece...
But if I'm gonna spend almost $80 on a sheet of diamondplate, then I'm gonna figure out other mods to make with the 2/3 of the sheet I don't use for this piece...
Champion
Joined: May 2008
Posts: 4,210
Likes: 0
From: Shreveport, LA
Hold on Ramhunter, you arnt saying that Hammer bought that shop to start a feminine toy manufacturing plant , are you???
Thread Starter
|
Administrator
Joined: Jul 2007
Posts: 24,686
Likes: 21
From: South Georgia/East Florida
Ok, final look. All polished. If you look at the stainless cross bar above it, it's pretty darn close to matching the stainless steel although it's aluminum...
