View Poll Results: How would you like the mount better?
Back the way it was (black powdercoat)
3
6.52%
This way (polished aluminum cover)
11
23.91%
Diamond Plate cover (to match my toolbox & bed rails)
32
69.57%
Voters: 46. You may not vote on this poll
Newest little mod and need an opinion...
Thread Starter
|
Administrator
Joined: Jul 2007
Posts: 24,686
Likes: 21
From: South Georgia/East Florida
ok, y'all win. I ordered a 4' x 8' sheet of .063" diamond plate today. I also con'd use of the shop wed of next week. Gonna punch a new winch mount plate out of the DP, make a set of grill inserts out of the polished stuff with bullet holes (not sure of hole size yet), make a matching insert for the scoop. So I'll have roughly 70% of the diamond plate sheet left. Any ideas?
Sorry Silver, I didn't see that I guess. You could make some cool engine dress up stuff. Like in the February totm thread Jim's SRT-10 has some cool plates that go on the rad and fuse box. You could punch stuff like that out with it?
Champion
Joined: May 2007
Posts: 2,687
Likes: 0
From: Northern Virginia
ok, y'all win. I ordered a 4' x 8' sheet of .063" diamond plate today. I also con'd use of the shop wed of next week. Gonna punch a new winch mount plate out of the DP, make a set of grill inserts out of the polished stuff with bullet holes (not sure of hole size yet), make a matching insert for the scoop. So I'll have roughly 70% of the diamond plate sheet left. Any ideas?
