Since they are weld in and you don't have a welder you might as well get some LT's, high flows and a full y-pipe and make yourself a full system. You can even do it without having to weld anything so you could do it all yourself right in the driveway.

 

lts are outta my $$ range

 

this is what moes sent me

Yep they're for 04-05, I just noticed the listing is F.U.B.A.R. I'll fix it.
They are "chrome" coated not ceramic coated shorty headers.
They're a direct bolt on replacement for the stock exhaust manifolds.

 

I think he may be Fubarred? he said shorties. And direct replacement.. i dunno bout all that, but i do know that thr tr-y design gives impressive low end and midrange torque.
Click HERE and then there is a download to show you a true pic of what needs to be done. You'll see.

 

i know i asked him about the direct replacement. dirty pm u email and i can send you the install instructions to see what you think about them...

 

haha first on their list is a Mig welder. Moe's is a fubarred...lol

 

i beat ya to it

 

thats only for step 12 i believe...

 

Step whatever...lol You'll still need one. i don't think band clamps and some heat tape will suffice....lmao
Looks like you'll have to take your headers off. Install the new headers to mark where to cut the flanges above the cats and weld on their flanges. It may even require a few times in/out of the headers as well as a chop job before hand to allow room for the new header to set in place. Chop job, I mean cut like 2 inches off the top of the cat right away becuz the new header may hit otherwise. not much room, hard to see. Kind of a time consuming PIA. You may get charged a pretty penny to install them.

 

oh ok wel idk if i want to do all that...