I am wanting to get rid of the factory y and was wanting to know if any body else has done this and what did you do?

 

Get a magnaflow y-pipe and have a shop cut out the old one and weld the new one in. Lots of guys in the 3rd gen section have had it done so if you search you should be able to find some prices on labor. I had mine cut out and they ran pipe back to a dual in single out magnaflow which has a y built in.

 

i like the flowmaster 40 series but its loud but it sounds good to me, i have a vid of it but if you dont want loud and wana sound mean go with flowmaster 50 series.

Sorry chambers but i like flowmaster's =D

 

+1 for the 50 series. i have one.

 

Doesn't bother me, but if you go w/ a flow you might want to pay more for a stainless one.

 

yea, i wish i got stainless for mine. its not so bad tho

 

the stainless doesn't bother me. my exhaust isn't stainless, so i don't care if the muffler is or not.

when my exhaust rusts through, i'll get a muffler too.

 

I got the 50 series and love it. No stainless here but no salt on the roads.

 

yup same here but i got 40 series and no salt on the roads here in texas

 

I wish I lived where the snow generally doesnt fall, here in Massachusetts were just exiting slush time for the monsoon season. Generally about now we here about global warming but knowone talks about global cooling at the end of November!

I just purchased an exuast off Ebay its not stainless but the extra 400 it would cost makes it out of my reach. I wish it had a Flowmaster 50 series in it but it's got a generic FlowSound muffler...But it will be a 50 series at the end of June if my budget goes as planned!