When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
3rd Gen Ram Tech2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Right where the oem muffler was clamped on, took that off and had it welded on with it dumped at the rear axle. I've heard pyro's setup and he has a lot of popping,(which I personally enjoy) but mine not so much. The only time it pops is when I'm wot and it shifts gears and then only a little. Mine may be different but of course I have the 4.7 and I got SISO 2.5 in and 2.5 out. He's running the SIDO like you got. Lovin' it though. You sure as hell get some head turns when you lay into that thing!!
now i gotta find a decent shop. dont wanna take it to a chain like midas but theyre the cheapest! but midas uses aluminized steel...should i go somewhere where i can get stainless or is aluminized no big deal?
I don't think I'd be too picky on the weld. I would however be kinda picky about the shop. If you're having duals with tips put on I'd just want to know about their quality of work. Such as will the duals be level with each other, the quality of the way they properly hang the system, etc. If I had to pay someone an extra few bucks to know it's done properly and they'd stand behind their work that goes a long way in my book. You don't have any strictly exhaust shops in Dallas? If you're leary about Midas then call around or stop by a shop or two.