I know there are a few threads on this already and I have read many of them and can't make up my mind.

Were am I going to get the most acurate reading.....

1.With a new pan and put the sender in the drain plug hole?
2.In Test Port number 3? (or other test port)
3.Inline - the line from the trany to the cooler?

I Think I know what guage and were i'm going to mount it just not sure were the best spot is for the electronic sending unit. Any inputs would be helpful thanks!

 

test port 3

 

Or get a Diablo Trinity and not have to have one at all........ ;-)

 

I have mine it test port number 3 and it works just fine.

 

AeroForce Intercepter gauge, plugs into OBDII port and reads everything (well almost) including trans temp. Totally plug and play.
Good luck..

 

you guys gettin paid for those promotions? lol he asked about a tranny temp gauge, not an alternate!

to the OP, if you havent bought one yet, i've got my whole setup i'll sell ya. PM me if you're interested

 

AF_Hemi,
I wish I was getting a little kick back. lol

OP,
I was just showing off about how smart I was by getting the AI, now if I could just use all of it's features that would really be something!


By pi_greg at 2010-06-16

 

Trans looks like it is running a little warm in this pic

 

Naw, that's the engine temp. The trans ususally runs at 144 degree. The trans never goes over 160 with the the 2500 HD trans cooler.

 

Hmm tell me more...how much are they what can they all read and how hard to install...Maybe a link?

Do you also have a link? I would rather have something like this if it's a plug and play and will read other things. What else will it ready by simply pluging it into the OBDII