I have the Sonnax on my truck and love it. I didnt notice too much of a difference until after I reset my PCM and then that **** started shifting really good. I could feel each shift and they all are much more profound. At WOT that SOB will jump forward when it shifts. I love mine.

 

Just to refresh, it really doesn't matter which wire to cut going to the sensor? Again great video, You should market, nevermind I just got a brain storm, I'm gonna make up twenty of these bad boys and try to sell them for ten bucks a pop at my next swap meet. whatdya think?

 

Yeah, either wire will work as long as you only cut ONE of the two wires. I used to make them and give them out at meets as i had them. I did sell one of two but that was mainly to pay for the materials.

 

^^^ looking at your sig pic, and thinking of all the success you've had (all hard earned), I think you should be wearing a three piece suit, next to that truck.

 

I have suits in my closet. All new and barely worn.

Have you went through all my pics in my sig link.

 

i havent in a while but i do enjoy them^^^

 

No not yet,
This guy^^^ needs to be more photogenic!!lol j/king

 

bump back ttt for the noobs

 

Does this work on my 5.9 liter? If so, which plug is it?

 

Do you have a IAT sensor or a MAF sensor?