I have an 2004 1500 4x4 with a 6 inch fabtech suspension lift and a 3 inch pa body lift. I want to know if anyone knows anything else I can do to lift the front end up any more and then put some blocks in the rear. I was going to get the torsion keys but the truck place said they would not work with the suspension lift.

 

you should be able to turn up the tosion keys and/or get the 2" lift ones i want to see a pic of your truck the way it is now though

 

Keys with a suspension lift is a no-no and especially with the poorly designed Fabtech lift which already puts a strain on the CV axles.
IMO if you want more lift, it's either time to fab in a SFA or trade the truck in on a 2500...

 

I got the same opinion as you, hammer.

The only "right" way to get more lift in the front with the IFS would be to install a new suspension lift designed for more lift. But, the problem is that the IFS should not have a tire on it that would be sized properly for amount lift IMO.

 

Thanks for your input and hammer what is a sfa mod cost, pictuers etc... I am working right now in posting my truck picture

 

heres my truck...

 

Looks good! Are those 35's on 20's?

 

Anywhere from a few hundred up to several thousands... all depends on if you have a spare axle and parts laying around and are a good fabricator, or if you are paying someone to fabricate and install "new" products.

 

SFA - Solid Front Axle. Basically you'd be converting your truck to a 2500. I'd be dropping in a heavier rear diff too. With older trucks it's not a really hard job, but with all the electronics and b.s. on the newer ones I'd imagine it would be pure hell

 

Yes they are 35's on 20 I gues they look alittle small and as for sfa thats way more money than I want to put into the truck.