3rd Gen Ram Tech 2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Mile 16,700: wear and tear report ('05 ram 1500 QC)

Thread Tools
 
Search this Thread
 
Old Feb 25, 2006 | 06:37 PM
  #11  
Chet Ubetcha's Avatar
Chet Ubetcha
3rd Gen Ram Moderator
Joined: Jul 2005
Posts: 1,596
Likes: 16
From: Cádiz, Spain
Default RE: Mile 16,700: wear and tear report ('05 ram 1500 QC)

Did your dealers not go over the vehicle with you when you were looking at it? If you bought second hand, I can understand, but there's no excuse for a dealer not to show the buyer everything about their vehicle.
 
Reply
Old Feb 25, 2006 | 06:55 PM
  #12  
BigRigTruckin66's Avatar
BigRigTruckin66
Veteran
Joined: Feb 2006
Posts: 377
Likes: 0
From:
Default RE: Mile 16,700: wear and tear report ('05 ram 1500 QC)

Well I guess this truck is full of surprises! Hey, did y'all know it doesn't open up full power until over 5,000k? That's right, there is a chip in the motor that doesn't unleash all the ponies until 5,000 so no stress comes from the test runs when someone slams the gas.
 
Reply
Old Feb 26, 2006 | 04:27 AM
  #13  
tamuccmike's Avatar
tamuccmike
Veteran
Joined: Dec 2005
Posts: 293
Likes: 0
From: Fort Worth, TX
Default RE: Mile 16,700: wear and tear report ('05 ram 1500 QC)

this is making me mad...i went out there again tonight to check for that storage under the center console...for those of you who have the storage there...does it go straight to the bottom where the carpet is, or is it like lined in plastic...my truck was $29,100 and i think it should have this storage space, i want to put my amp there...I do not feel any handles or anything, and it doesn't look to me like that center part would come up to provide storage...i dunno i just want that...thanks guys!
 
Reply
Old Feb 26, 2006 | 04:38 AM
  #14  
BigRigTruckin66's Avatar
BigRigTruckin66
Veteran
Joined: Feb 2006
Posts: 377
Likes: 0
From:
Default RE: Mile 16,700: wear and tear report ('05 ram 1500 QC)

It is a plastic lever and should be able to slip your hand under it and pull and should pop up. You need the middle seat for it to. If ya don't get it by tomorrow, I'll post a guide since I'm that nice.
 
Reply
Old Feb 26, 2006 | 09:08 PM
  #15  
tamuccmike's Avatar
tamuccmike
Veteran
Joined: Dec 2005
Posts: 293
Likes: 0
From: Fort Worth, TX
Default RE: Mile 16,700: wear and tear report ('05 ram 1500 QC)

after further inspection i have just about determined that i do not have this...but i will still take the instructions/picture on how it works...im 99% certain that i dont have it though, what a dissapointment
 
Reply
Old Feb 26, 2006 | 09:31 PM
  #16  
BigRigTruckin66's Avatar
BigRigTruckin66
Veteran
Joined: Feb 2006
Posts: 377
Likes: 0
From:
Default RE: Mile 16,700: wear and tear report ('05 ram 1500 QC)

There is a guide up in here by me with pics and details, give 'er a try!
 
Reply
Old Feb 27, 2006 | 09:30 AM
  #17  
HankL's Avatar
HankL
Champion
Joined: Aug 2005
Posts: 3,313
Likes: 8
Default RE: Mile 16,700: wear and tear report ('05 ram 1500 QC)

magnethead,
thanks for the good write-up
please keep reporting in
as the mileage piles up at the rapid rate that you are going at.
 
Reply




All times are GMT -4. The time now is 02:22 PM.