Built a C.A.I at work this week just to try it out,I copied someone's post,3" pvc 2 90's spectre cone and breather.Fitted,Glued and Painted it up Etc.Anyhow now from a dead stop at a light I hit the gas and nothing for almost a second?I cleaned the throttle body before install.after the first drive i noticed the rpm's wanted to surge a little after a stop,so i went back to work and reset all my parameters with our snap-on scanner.I'm clueless it only hesitates from sitting at a light for a minute,It does'nt do it from a stop and go.???? Thanx D...

 

I would rather doubt a CAI would cause the hesitation, they really don't do much but increase the airflow a bit.

Did you remove the TB when you cleaned it?

 

Sounds like the throttle blade sticking to me.

 

I was thinking either that or he gummed up the sensor...

 

thanx for the reply,i'll take the tb back off and clean it out again,it was pretty nasty on the backside...

 

Be careful not to get anything on the sensor, even a thumb print will pretty much make one FUBAR...

 

Hammer,lxman1-Took the throttle body back off and cleaned it again;even though it was spotless.She's running Top's now,I'm not Happy cause i spent 8 yrs. in the Marines and i know i missed some sh*t in her hole somewhere...Hammer The Walleyes are starting to Hit up Here.You Guys Have Free Room,Board Up here anytime you want...Good Fishin' and Good People...Thanx D....