mandrel bent piping & also headers?
#1
mandrel bent piping & also headers?
alright so this is getting on my nerves, do they make just a kit for mandrel bent piping for 3" from the cats to the tip?
i want 3' and then get the muffler i want but mandrel bent and 3'
if anyone can help id really appreciate it
if not i might go with this banks exhaust anyone have it?
i wanted the autoturbine but not sure if im going to spend 200 just for a muffler
thanks for the help
i want 3' and then get the muffler i want but mandrel bent and 3'
if anyone can help id really appreciate it
if not i might go with this banks exhaust anyone have it?
i wanted the autoturbine but not sure if im going to spend 200 just for a muffler
thanks for the help
#2
#4
RE: mandrel bent piping
You really don't need 3" on a 'small' motor like a Hemi. The 3" could harm your performance more then it will help it. A internal-combustion engine needs backpressure to perform correctly, and the three inch will most likely not supply enough of it to benefit you. I know they sell 3" and 3.5" systems for trucks, LS1 Camaros and Firebirds, and mustangs, but they are a complete waste of money. 3" exhausts are unneeded until about 500 horse. I know some guys running 700+ horsepower 540 cube Big Block Chevys that are only running 3" and it doesn't hurt the motor at all.
Chris
Chris