Hello Everyone,

I'm new to this forum, but I really need some help. I've done a lot of research on the web and I'm still a little confused. My 03 hemi 1500 will not hardly run. I was driving home from work and it started spitting and sputtering all of the sudden. I pulled over and that's where it has been since last week. The truck will not run unless you press the gas and then it barely runs. The codes are: p2016 ETC System - Forced Limited Power (2 times displayed on scanner), p2111 ETC System - Stuck Open, p0222 TP Sensor #2 Circuit Low, p0123 TPS Voltage High. Any suggestions on how to fix this? I cleaned the TB and tried another TB on it. Nothing has helped! I need help PLEASE!

 

Was the throttle body you tried new?

 

No, It was one off of a 03 just like mine, but it looked really clean. I put it on my truck and it didn't help. I put his TB back on his truck again and it worked fine. I noticed that my TB sensor pigtail does not have power to it when the key is on or the truck is running.

 

How is the battery and battery connections?

 

The battery had some corrosion, but I cleaned the terminals. I believe the battery was fine before this happened. It would be a little sluggish on very cold mornings, but it would still crank.

 

Bad grounds, weak batteries cause alll kind of issues on computer controlled vehicles.

 

Ya I will have the battery checked, but that still doesn't explain why the pigtail to the TB sensor doesn't have any power to it.

 

I have a 2008 dodge ram 1500 4x4 with the 5.7 hemi I drove home one day with no problem then when I got back up to go to work I had no gears over 2nd and it throws the code p 0733 how do I fix this??? please help

 

I checked the codes by flipping the switch 3 times and these codes were present: p2106, p0129, P0112, p0113, p1618, p0123, p0222, p2111, p2106

 

Change the fuel filter and check the fuel pressure.... Fuel pump might be weak.