3rd Gen Ram Tech 2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

How Safe to Drive with Bad Front U Joints

Thread Tools
 
Search this Thread
 
Old Jun 2, 2015 | 08:22 PM
  #11  
gcburkett's Avatar
gcburkett
Veteran
Joined: Feb 2011
Posts: 437
Likes: 1
From: Chicago suburbs
Default

http://www.rockauto.com/catalog/more...id=495&jpid=34

Its the front axle shaft. The Moog part is 464 and cost $43 at RockAuto. There are certainly cheaper ones if you want.
Get the Moog is you want greasable or go with the Dana if you want non-greasable.

http://www.oreillyauto.com/site/c/se...500&vi=1424674

Here is a O'Reillys if you have one of them. But if you have not change anything like them before you have to get the wheel hubs off. Getting the hub off can be difficult there are youtube videos showing methods to get them off.
 
Reply
Old Jun 2, 2015 | 09:01 PM
  #12  
042500moltenred's Avatar
042500moltenred
Thread Starter
|
Registered User
Joined: Jun 2014
Posts: 21
Likes: 0
Default

Does anyone have the part number for the spicer u joints. Also should I get greaseble spicer or non greasable?
 
Reply
Old Jun 4, 2015 | 11:16 PM
  #13  
66three83's Avatar
66three83
Captain
Joined: Mar 2010
Posts: 725
Likes: 14
Default

Getting the bearing out is damn near impossible on anything older than 2 years!!!!
 
Reply




All times are GMT -4. The time now is 07:33 PM.