When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
3rd Gen Ram Tech2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
I managed to get everything swapped out and back together. Things were stuck pretty firm, but luckily I didn't need much more than a breaker bar on the wrench. Thanks for all the help
Josh - Not sure about your truck, but with the independent suspension, I found I did have to remove the upper ball joint from the knuckle, but I did not have to remove the tie rod end. There is not enough clearance to access the bolts even with the wheel turned. The end of the half shaft takes up too much space in the knuckle.
That's odd, I never had to pop mine. Mine is obviously a 4x4 as well. I'll take some pics and we'll compare notes ;-)
