Truck got the dtc for the tcc solenoid, it started stalling at stops, if I'm sitting still in gear with foot on brake, and give a little gas the rims fluctuate while holding steady on accelerator then dies after letting off gas.

 

Guess my torque converter is locked and when I'm coming to a stop it stalls, the torque converter lock up solenoid is bad

 

Just found out my tranny has 15 bolts which makes it the 45RFE, looks like these have a solenoid block which is everything built into one, also says there is an updated block with a white plug that replaces mine , is this the same solenoid that controls everything?

 

Check your Transmission fluid at normal operating temp. If it is low, it will stall out when stopping. I just had this issue and discovered when I changed the fluid, I didn't fill it all the way. I should have checked the level after letting it sit for a spell after refilling.

 

Did it give you a cel? It has to be in neutral also correct?

 

Thank you

 

Also if I would go out in the morning and start my truck to let it warm up, when I get ready to leave and put it in gear it kicks in kinda hard

 

I did not get a code, it was just stalling.

 

I got a code for torque converter clutch solenoid

 

How low was your fluid? Mine is about 1/2 inch from the top hole on the dipstick