I purchased a set of Supersprings for my 2004 1500 Hemi to do some towing and ran into a snag on the right rear. Seems the tail pipe from the exaust (Original exhaust) sits too close to the original truck springs and I am unable to install the Supersrpings bracket on that side -- driver side fit great. It just don't fit without rubbing! Anyone else have this problem or solutions?

 

It should be ok once its on the ground, i had a simular problem when instlling my flip kit.

Once it was put back on the ground it was ok.

 

Did that work? I am about to put a set on my 05 qc 4x4. The springs are sitting in my garage right now. I am also going to be putting a gibson single side swept exhaust on as soon as it gets here. Will that be a problem? Has anyone else installed these?