Any one know how to turn off the seat belt alarm on the 2006Dodge Ram 2500? I hate to back up my boat trailer and have to buckle up so I don'thear that alarmsound..... I alreadycheck the manual?? Help

[IMG]local://upfiles/57742/82C1F15457A540FEA520054AF1812EF5.jpg[/IMG]

 

If I remember correctly you get in the truck buckle the belt then turn the key to the run position (do not start) Then unbuckle and rebuckle the belt 3 times leaving it buckled the last time then turn the key off.
You should hear a chime if you did it right, then unbuckle the belt and you should be good to go.

 

I have two 2004 and i take the buckle in the mid and put it in the drivers. It will tune off.

 

Thats a good idea, I thought of that as well but I know atleast on the 07 the mid belt input is bigger and wont plug in to the drivers side

 

I went to the dealership and asked them to provide seat belt extenders due to wearing a brace for a broken back.

After healing the extension can be cut to go into the buckle. MA state law requires dealers to provide seat belt extenders free of charge if requested - I was told. Otherwise a trip to the junk yard should yield a buckle.

 

I DO NOT condone this, nor does this or any other site:

let the signal go. search under the dash for the source.

remove the buzzer module from the fuse block.

FEDERAL AND STATE LAWS REQUIRE THE SEAT BELT WARNING SIGNAL TO BE ACTIVE FOR SAFETY.

 

It's on page 44 of the 2006 manual. It tells you how to disable the chime. I did it in mine. Piece of cake.

 

I done this.... this morning before I went to work and it shut the chime up Will it still be disabled after I shut the truck off or does this step need to be repeated everytime

 

Yes it will still be disabled after you shut the truck off. If you want to re-enable the chime, just repeat the procedure.

 

Thanks Guys I will try this

[IMG]local://upfiles/57742/EB99628A80FD4F95B176FC6256D93323.jpg[/IMG]