Oil Change Reminder Issues
Champion
Joined: May 2009
Posts: 3,497
Likes: 1
From: MN
Those of you who are getting it at exactly 2500, do you have early build trucks with the "other" engine? Makes me wonder if either the early engines or early firmware are hard coded to 2500. The one time my light came on was around 3K. I get the oil changed every 2500 miles so I wouldn't normally see the light - dealer resets at each oil change.
Thread Starter
|
Registered User
Joined: Mar 2009
Posts: 5
Likes: 0
From: Montana, USA
Those of you who are getting it at exactly 2500, do you have early build trucks with the "other" engine? Makes me wonder if either the early engines or early firmware are hard coded to 2500. The one time my light came on was around 3K. I get the oil changed every 2500 miles so I wouldn't normally see the light - dealer resets at each oil change.
Captain
Joined: Feb 2009
Posts: 563
Likes: 0
From: AZ
Unless reset, this message will continue to display each
time you turn the ignition switch to the ON position. To
turn off the message temporarily, press and release the
Trip Odometer button on the instrument cluster. To reset
the oil change indicator system (after performing the
scheduled maintenance) refer to the following procedure.
1. Turn the ignition switch to the ON position
time you turn the ignition switch to the ON position. To
turn off the message temporarily, press and release the
Trip Odometer button on the instrument cluster. To reset
the oil change indicator system (after performing the
scheduled maintenance) refer to the following procedure.
1. Turn the ignition switch to the ON position
(Do not
start the engine).
start the engine).
2. Fully depress the accelerator pedal slowly three
times within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
times within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE:
If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
start the vehicle, the oil change indicator system did not
reset. If necessary repeat this procedure.