Wiring Question - MOPAR TECH out there..
#1
11-10-2010 | 08:50 AM
Thread Starter
|
Veteran
Joined: Mar 2009
Posts: 325
Likes: 0
Wiring Question - MOPAR TECH out there..
When you use the Remote start the inside electronics come on, however things off of the ignition do not. The DVD headrest setup I have doesn't come on with the remote start. Does anyone know if it is possible to change the wiring to have my DVD headrests come on with the remote start, and stay on when the key is inserted?
I'm not sure if this is possible without some type of voltage sensor. If the wire that has 12volts is live when you activate the Remote Start, it might go dead when the key is inserted....
Anyone a MOPAR technician
I'm not sure if this is possible without some type of voltage sensor. If the wire that has 12volts is live when you activate the Remote Start, it might go dead when the key is inserted....
Anyone a MOPAR technician
#3
11-12-2010 | 07:06 AM
Thread Starter
|
Veteran
Joined: Mar 2009
Posts: 325
Likes: 0
What Wire provides 12volts during & after remote start
The wire I need to find is the wire that when you activate your remote start it has 12volts, but when you put the key in it stays at 12volts. The wire can't give 12volt unless the remote start is activated OR the key goes in and the accessory position or ON is turned...
any takers?
any takers?