Doing some test runs again with the Ram. I have a K&N intake, diablo 91 tune, and magnaflow catback. 3.55 gears. One of the vids I lost too much traction and couldnt recover the torque curve, but still super impressive. I think if i could keep traction I could easily have a 4.5-5 second 0-60
http://www.youtube.com/watch?v=zDGyQ0KjKgM
http://www.youtube.com/watch?v=kuyOVdYpzGg

 

That thing is fast!

 

In the second video it sounds like your tranny slips in second...it grabs traction in second and then slips at around 40 to 50 in the vid. Either that you hit a slippery spot in the road...nice vid, lol!

 

not bad...now try to get some traction and maybe give my dakota a run! lol

 

Damn Maine roads are filled with potholes. I did hit one, and it bounced the tranny out of gear. Those are brand new tires too that I'm loosing grip with. Thanks guys for comments.

 

Sorry to burst your bubble but with your mods you will be lucky to do a 0 to 60 below 6 seconds. These trucks are fast but they arent that fast. In your first vid posted it looks to me like you hit 60 in a little over 7 seconds and you weren't spinning your tires enough to justify a 2 second loss in your time.

 

I wouldnt say you "burst" my bubble. I think on a health clean hook up, 5.5second-6 seconds is doable. Which is lethal Id say for some basic mods on a 6000lb truck, nothing none of you guys can't do either.

 

i will give you 6 seconds. you have to remember that the reg cab short box r/t truck with a special high stall torque converter and 4.10 gears hits 60 in about 5.7 to 6 seconds flat. so 6 is not out of the question but you will need more mods then you have to get there.

 

Well I like the vids....wish my truck would do that, I have 355's also, I can get rubber but only if I am coasting from a dead stop I get nothing till about 20 mph then its like someone kicked my butt.

 

Im done modding. I need to pay payments now lol.