Dodge Caravan The Dodge Caravan is the best selling mini van from Dodge. How many Dodge Caravan owners here at DodgeForum.com would agree? Discuss it now!

stalling and a code PO134 ?

Thread Tools
 
Search this Thread
 
Old Aug 2, 2013 | 12:18 PM
  #1  
THavens's Avatar
THavens
Thread Starter
|
Registered User
Joined: Aug 2011
Posts: 6
Likes: 0
Default stalling and a code PO134 ?

This is a new problem for the 97 grand caravan with a 3.8 Lt engine -

It will stall intermittently at idle and mostly when in gear and with the AC on but also will stall when idling when not under load. While I'm watching it will run fine for 5 to 10 minutes then just stop - I'd call it a hiccup - it doesn't drag this out with shudders of coughs - it just stops.

It's pulling a po134 code - O2 Sensor CKT No Activity ( Bank 1 Sensor 1)
I've replaced the O2 sensor in front of the catalytic converter which did not stop the stalling.
The car is not throwing any other codes
Any ideas on what I should look into.

Thanks to you all for being out there - I could never fix that car with just the worthless manual. I search the archives for the code but nothing came up.
THavens
 
Reply
Old Aug 2, 2013 | 04:13 PM
  #2  
Cougar41's Avatar
Cougar41
Record Breaker
Joined: Feb 2011
Posts: 2,256
Likes: 2
From: SoCal
Default

Will it restart right away? Still getting the P0134 code? When it stalls are you loosing all power or just the engine?

Usually stalling out of the blue points to either a failing cam or crank sensor and they often fail without throwing a code. You can verify they are getting a reference voltage from the PCM and they're getting a good ground. Loss of power to the ign coil and injectors points to a failed sensor. You're not seeing the typical symptoms of a failing fuel pump but it would be a good move to verify the pump is working when it stalls. Check pressure with a gauge or depress the plunger in the fuel rail test port. Fuel should squirt and not dribble.
 
Reply
Old Aug 3, 2013 | 11:59 AM
  #3  
THavens's Avatar
THavens
Thread Starter
|
Registered User
Joined: Aug 2011
Posts: 6
Likes: 0
Default

Thanks for your quick response Cougar41- I need that van

So - I had not checked to see if the power to the whole car stopped .
First I'll do that then I'll check to see if the sensors are getting the right juices .
Thanks again Cougar41.

THavens
 
Reply
Old Aug 11, 2013 | 08:07 PM
  #4  
THavens's Avatar
THavens
Thread Starter
|
Registered User
Joined: Aug 2011
Posts: 6
Likes: 0
Default

Thanks again Cougar 41 - - after a lot of reading on the stalling issues I decided to go ahead and and take your advise and change out the CPS .The tests you advised pointed to a failed Crankshaft position sensor. The van is running again and my wife is happy ! ! ! !

THavens
 

Last edited by THavens; Aug 11, 2013 at 08:12 PM.
Reply
Old Aug 12, 2013 | 04:41 AM
  #5  
Cougar41's Avatar
Cougar41
Record Breaker
Joined: Feb 2011
Posts: 2,256
Likes: 2
From: SoCal
Default

Nice work. Glad to hear all is well.
 
Reply




All times are GMT -4. The time now is 10:53 PM.