Driver Power Seat dead in full recline.

Subscribe
Oct 10, 2021 | 08:13 PM
  #1  
Help :-) my 2014 SXT driver power seat went into full recline and is dead. I have read on several sites there is a circuit breaker that can be reset but I don't know where it is other than it's located on the trailing edge of the seat. With the seat in full recline I have very little room to look for it. A picture of the breaker/reset would be great or a better description of the location. I did find a green wire with a black tracer at the seat switch that has the dreaded seat frame wear to bare wire that probably caused the problem and I can fix that but need to find the reset. I would rather not have to remove the seat from the van but can if I have to. Thanks in advance for any assistance.
Reply 0
Oct 12, 2021 | 01:06 AM
  #2  
Check the fuses in the PDC/IPM. I think it was fuse 23.
Reply 0
Oct 30, 2021 | 08:39 PM
  #3  
I was able to fix the problem, There was a green wire with a black tracer that had the insulation wore down to the conductor and shorted out the 40A fuse under the hood. After repairing the wire and finding a "J-Case" fuse it is alive again.
Reply 0
Subscribe